Whimsy Stamps - You're My Penguin Hero

Hi Everyone,

Hope you are all having a fantastic week, I have been busy putting in extra hours at my "normal job" so haven't been around much.. my apologies.

Today I am sharing with you a card I have made for Whimsy Stamps using Penguin Super Hero, he is available in both Rubber and Digital - I will have both versions linked up below for you.

I actually coloured this image up a while ago but had not had a chance to get him onto a card so the New Release was the perfect time to showcase him again. He is on X-Press It Blending Card Stock ready for Copic Colouring.

I fussy cut the image out once I had him ready to go using my EK Success Cutterbee scissors, these scissors are seriously amazing, so if you are after a super sharp super pointy pair of fussy cutting scissors these guys are your go to.

I used MFT Stamps Star Stax dies, I used some washi tape to adhere two of them together so I was able to cut out a frame using some black American Crafts Cardstock, I then ran the smallest star back through using some of the coloured paper from the Hampton Art Celebrate Patterned Paper Pad using my Sizzix Big Shot.

I cut a red piece for matting from the same  patterned paper pad and then a pice of the dot/star pattern. I adhered those two layers to a Couture Creations Card Base using Glue Dots Permanent Glue Squares Tape Runner.

I used some washi tape to adhered the star frame and the green insert piece together before I adhered them to my card, just to make sure that they were lined up perfectly.

I used Mama Elephant Congrats Die and ran it through my Big Shot using an orange piece of scrap from the same patterned paper pad (all the sheets have a plain side and a patterned side). I then decided it needed to pop off my card more.. I don't have a frame word die for this one so I traced the outside of the die onto some X-Press It Blending Card using a mechanical pencil then using my Cutterbee Scissors I fussy cut it out then carefully used an eraser to take away all the pencil lines. I then using American Tombow Mono Multi Liquid Adhesive I adhered the two layers together. I adhered it to the star using the same liquid adhesive.

I trimmed the two sentiments down (they came from the rubber stamp) and adhered those and the image to my card using American Crafts foam dots.

Finally I added some Wink Of Stella to the image and the star and it was complete.


I hope you have enjoyed my post today, if you have any questions feel free to send me a message or contact me via facebook (al links can be found below).

Watch the You Tube Video Here




Products Used On My Card (Affiliate Links Used Where Possible)





Copic Markers Used

no list sorry

Thanks for stopping by, Deni

CAMERA SET UP - FOR YOU TUBE VIDEOS ONLY
Blue Yeti Microphone
Sony Handycam HDR CX4-05
Tripod – Manfrotto MKCompactaCN-BK

S O C I A L MEDIA 
B L O G : https://ldli.co/e/3xky6x  
I N S T A G R A M : https://ldli.co/e/5dn20x
YOU TUBE: https://ldli.co/e/ej5l90
F A C E B O O K: https://ldli.co/e/mjxn2r
PINTEREST: https://ldli.co/e/2l9zom


I was a 2018 Ambassador for Copic Marker Australia and NZ