Honey Bee Stamps - You shine to me

Hi Everyone,

Today I am using a gorgeous new stamp set (to me) from Honey Bee Stamps called Shine On. I really love this stamp set, unfortunately when I ordered it was out of stock so I had to wait for it. It finally arrived and I was so busy I wasn't able to use it until now.

I stamped the nail polish bottle out 3 times onto X-Press It Blending Cardstock using Memento Tuxedo Black using a Lawn Fawn Acrylic Block.

I ran the images through my Sizzix Big Shot using the matching dies (Which I had cut apart using my wire cutters), I used a small piece of washi tape to hold the die in place so they did not move as I ran them through.

Using some glitter card stock I ran the bow die through a couple of times. I used the same glitter card stock and stamped out the nail polish bottles out onto the reverse side.. I used my EK Success Cutterbee Scissors to cut just the bottom part of the bottle.

I ran the bow die through a second time using some vellum and layered it over the glitter card, just using adhesive on the centre so the sides popped off the bottle a little bit. I coloured the reverse of the centre using Copic Markers just to keep that bright colour going.

I grabbed another Honey Bee Stamp Set - Happy Birthday, I stamped the sentiment out onto Vellum using Ink On 3 Embossing Ink, Super Fine White Embossing Powder from Ranger Ink and melted it using my Heat Tool. I also prepared the vellum beforehand using a powder tool. I then used my EK Success Cutterbee Scissors to fussy cut the sentiment out.

I grabbed the Nail Polish bottles that I first cut out and coloured them up using Copic Markers (you can find them listed below).

  

I used my Helmar Acid Free to start layering up the Nail Polish bottles, I adhered the glitter layer I cut down earlier to the bottom of the bottle, then the bows on top of those and the vellum layer of bow.

  

I used Paper Rose Jumbo Numbers and ran them through my Big Shot using American Crafts Black Cardstock, I used my Uni-Ball white gel pen to add some details to the numbers and add the TH to the 6.

I began adhering all the layers to a Couture Creations Card Base using Helmar Acid Free.

To finish the card off I used Tonic Studios Nuvo Crystal Drops in Silver Moondust.

I hope you have enjoyed my post today, if you have any questions feel free to send me a message or contact me via facebook (all links can be found below).

Watch the You Tube Video Here



Products Used On My Card (Affiliate Links Used Where Possible)




Copic Markers Used

T1, T4, 0 Colorless Blender
R17
R83

Thanks for stopping by, Deni

CAMERA SET UP - FOR YOU TUBE VIDEOS ONLY
Blue Yeti Microphone
Sony Handycam HDR CX4-05
Tripod – Manfrotto MKCompactaCN-BK

S O C I A L MEDIA 
B L O G : https://ldli.co/e/3xky6x
I N S T A G R A M : https://ldli.co/e/5dn20x
YOU TUBE: https://ldli.co/e/ej5l90 
F A C E B O O K: https://ldli.co/e/mjxn2r
PINTEREST: https://ldli.co/e/2l9zom



I was a 2018 Ambassador for Copic Marker Australia and NZ